Access Panel

Access Panel

To help ensure that our projectors are easy to maintain we have designed and created our own bespoke access panel system which provides simple access for re-lamping and maintenance. The access panel has a circular metal outer ring and a choice of a blank centre panel or one with a hole for fitting a down lighter.

Our standard circular access panel has a diameter of 175mm and we also offer a square access panel with a width of 175mm, both have a plate that is approximately 1.5mm thick. If you need a larger access panel just let us know and we’ll be happy to make something to suit your requirements.

Access Plate

Each access plate comes as two parts A and B as shown in attached photos.

Photo 'A' shows bottom of access plate at 175 mm diameter. This is approx. 1.5 mm thick.
This plate can be made to a larger size if required and also have a hole cut in it to take a downlighter.

Photo 'B' shows ceiling ring cut out size is 160 mm the top flange is 220 mm diameter.

Fitting Instructions

Cut through the sidewall of part B and corkscrew flange through the ceiling, pulled down so bottom edge is flush with ceiling and plastered in. (if being fitted into single plaster board it will be necessary to pack the flange up using a plaster board ring.

Once in place the access plate can be fitted without damage to ceiling.

Want to find out more?

To find out more about our bespoke framing projectors get in touch with Mark or Adam Harris on 0208 848 4761.